12 or 24 Volts DC
The GMM-IP67-LVS wireless Low Voltage Sensor is designed to stand up to the harsh marine environment & is set to trigger an alarm when the voltage drops below 11.6v (on 12V Sensor) or 23.2v (on 24v sensor) for more than 2 minutes. This sensor will monitor any 12V or 24V battery bank. There is a dip switch on the circuit board that allows installers to switch the voltage monitored between 12 or 24 volts DC.
It includes a mounting bracket for the float switch that should be installed in the bilge of the vessel slightly below the vessels factory installed high water sensor.
The GMM-IP67-TempSensor wireless Temperature Sensor’s enclosure is designed to stand up to the harsh marine environment and is set to trigger an alarm when the temperatures exceed or drops below a preset temperatures range. The coil sensor itself can be mounted virtually anywhere in the vessel where temperature threshold alarms are needed.
Freezer Temperature Sensor
The GMM-IP67-Freezer wireless Freezer Temperature Sensor is designed to monitor the temperature inside the vessel’s food, ice storage & bait freezers and will alert up to 8 people with a voice phone call and/or text message if the temperature rises to 39°F (+/- 5°F). The IP-rated, wireless, battery powered GOST Freezer Sensor is available as an add-on to any GOST Phantom, GOST Insight HD or GOST NT-Evolution System.
Heat Temperature Sensor
The GMM-IP67-Heat wireless Heat Temperature Sensor is designed to monitor the temperature inside the vessel’s food, ice storage & bait freezers and will alert up to 8 people with a voice phone call and/or text message if the temperature reaches 160°F (+/- 5.4°F) and will reset when the temperature reaches 130°F (+/- 10°F). The IP-rated, wireless, battery powered GOST Heat Sensor is available as an add-on to any GOST Phantom, GOST Insight HD or GOST NT-Evolution System.
Our Long Range Water Resistant wireless Door/Hatch sensor works with any of our available extension sensors. It is compatible with the GOST Phantom, GOST Insight HD or GOST NT-Evolution Systems. This wireless design also has a built in anti-tamper switch.
• Wireless range in a typical marine environment:
35m (115ft) with GOST Phantom, GOST Insight HD
or GOST NT-Evolution Systems that can be extended
to 70m (230ft) with the Wireless Repeater
• Low battery and signal transmission LED
***One of the extension sensors to the right is required***
4″ x .5″ Exterior Surface Mount Switch Set *SUPER HEAVY DUTY* up to 3-inch gap between sensor and magnet
Deck Pressure Sensors
The GMM-IP67-DS wireless Deck Sensor is designed to protect the exterior or interior of the vessel. The sensors are epoxied to the underside of the vessel’s deck where they cannot be seen by intruders. In addition, they will not detract from the vessel’s decor. These sensors are effective on almost any boat structure including wood, fiberglass and even aluminum or steel decks. Environmentally sealed and utilizing 22-gauge marine grade wire leads, these sensors are ideal for those hard to protect areas of the vessel where there is access to the underside of the deck. They will not respond to vibration, shock, or airborne items. They sense only the unique flexing of the deck caused by a person walking. Sensitivity is fully adjustable from the processor. They can even be used to protect ladders up to the fly bridge or tuna tower. These sensors are sold as arrays. We offer a 2 & 4 sensor array.
For fiberglass and wood decks:
GMM-IP67-DS2: 2 sensor array
GMM-IP67-DS4: 4 sensor array
For aluminum or steel decks:
GMM-IP67-DS2M: 2 sensor array
GMM-IP67-DS4M: 4 sensor array
Infrared Beam Sensor
The GMM-IP67-IBS wireless Infrared Beam Sensor is designed to protect the exterior of the vessel. There is an invisible infrared beam shot between the emitter and the detector (photoelectric eyes). Once the infrared beam is broken the sensor is activated and causes the system to go into alarm. These sensors are commonly installed in the gunwales to protect the cockpit areas. Other uses include open fly bridges to protect the electronics or any other exposed areas where a motion detector is not practical. These sensors have a built in fail safe amplifier and are resistant to sunlight and other interference.
These sensors are available in the following versions:
GMM-IP67-IBS1: 1 pair of photoelectric eyes
GMM-IP67-IBS2: 2 pairs of photoelectric eyes
GMM-IP67-IBS1-Siren-Out: 1 pair of eyes with siren output
GMM-IP67-IBS2-Siren-Out: 2 pairs of eyes with siren output
The GOST GMM-IP67-Pull wireless Pull Sensor has developed multiple uses over the years. It is used like a continuity line and when the line is broken the sensor is triggered. Notification is given if the boat is pulled away from the dock or a tender is pulled from the back of a vessel. It is also possible to install the sensors in several different ways. They can be installed with the female end on the dock or the mother ship, or they can have the male & female on the same vessel, which lends itself to more versatility.